| Hardware |
| Standard Support |
IEEE 802.11b/g/n
IEEE 802.3
IEEE 802.3u
IEEE 802.3x |
| Memory |
32 Mbytes DDR SDRAM
4 Mbytes Flash |
| PoE |
Passive PoE |
| Interface |
Wireless IEEE 802.11b/g/n, 1T1R
PoE LAN (LAN 1): 1 x 10/100BASE-TX, auto-MDI/MDIX, passive PoE
LAN 2/ WAN: 1 x 10/100BASE-TX, auto-MDI/MDIX |
| Antenna |
Internal (Default): 12dBi directional antenna
■ Horizontal: 30 degree
■ Vertical: 20 degree
External (Option): RP-SMA type Connector
■ Switchable by Software
■ For External Antenna Mode, attach antenna before power on |
| Wireless RF Specifications |
| Wireless Technology |
IEEE 802.11b/g
IEEE 802.11n |
| Data Rate |
IEEE 802.11b: 1, 2, 5.5, 11Mbps
IEEE 802.11g: up to 54Mbps
IEEE 802.11n (20MHz): up to 72Mbps
IEEE 802.11n (40MHz): up to 150Mbps |
| Media Access Control |
CSMA/CA |
| Modulation |
Transmission/Emission type: OFDM
Data modulation type: OFDM with BPSK, QPSK, 16-QAM, 64-QAM |
| Frequency Band |
2.412GHz ~ 2.484GHz |
| Operating Channel |
America/ FCC: 2.414~2.462GHz (11 Channels)
Europe/ ETSI: 2.412~2.472GHz (13 Channels) |
| RF Output Power (Max.) |
IEEE 802.11b: up to 26 ± 1dBm
IEEE 802.11g: up to 21 ± 1dBm
IEEE 802.11n: up to 17 ± 1dBm |
| Receiver Sensitivity(dBm) |
IEEE 802.11b: -97dBm
IEEE 802.11g: -90dBm
IEEE 802.11n: -90dBm |
| Output Power Control |
5-level TX power control |
| Software Features |
| LAN |
Built-in DHCP server supporting static IP address distribution
Supports UPnP
Supports IGMP Proxy
Supports 802.1d STP (Spanning Tree) |
| WAN |
■ Static IP
■ DHCP (Dynamic IP)
■ PPPoE
■ PPTP
■ L2TP |
| VPN Passthrough |
■ PPTP
■ L2TP
■ IPSec
■ IPv6 |
| Operation Mode |
■ Gateway
■ Bridge
■ WISP |
| Firewall |
NAT firewall with SPI (Stateful Packet Inspection)
Built-in NAT server supporting virtual server and DMZ
Built-in firewall with port/ IP address/ MAC/ URL filtering |
| Wireless Mode |
■ AP Bridge
■ AP Router
■ Client Bridge
■ Client Router (WISP)
■ WDS PtP
■ WDS PtMP
■ WDS Repeater
■ Universal Repeater (AP+Client) |
| Max. SSID |
Up to 5 |
| Channel Width |
20MHz / 40MHz |
| Wireless Isolation |
Enable to isolate each connected wireless client so that they cannot access mutually |
| Encryption Type |
64/128-bit WEP, WPA, WPA-PSK, WPA2, WPA2-PSK, 802.1X |
| Wireless Security |
Wireless LAN ACL (Access Control List) filtering
Wireless MAC address filtering
Supports WPS (Wi-Fi Protected Setup )
Enable/Disable SSID Broadcast |
| Max. Wireless Clients |
10 |
| Max. WDS APs |
8 |
| Max. Wired Clients |
30 |
| WMM |
Supports Wi-Fi multimedia |
| QoS |
Supports Quality of Service for bandwidth control |
| NTP |
Network Time Management |
| Self Healing |
Supports Schedule Reboot |
| B/G Protection Mode |
Supports protection mechanism to prevent collisions among 802.11b/g modes |
| IAPP Roaming |
Supports IAPP (Inter Access Point Protocol) roaming |
| Management |
Web UI, DHCP Client, Configuration Backup and Restore, Dynamic DNS |
| Diagnostic Tool |
System Log |
| Mechanical and Power |
| IP Level |
IP55 |
| Material |
Outdoor UV-resistant enclosure |
| Dimensions (W x D x H) |
127 x 63 x 254 mm |
| Weight |
485g |
| Installation |
Pole mounting or wall mounting |
| Power Requirements |
LAN1
■ 12V DC, 1A/ passive PoE
■ Pin 4 V DC+
■ Pin 5 reset
■ Pin 7,8 V DC- |
| Power Consumption(Max.) |
12W |
| Environment and Certification |
| Operating Temperature |
-20~70 degrees C |
| Operating Humidity |
10~95% non-condensing |
| Regulatory |
CE, FCC, RoHS |
| Accessory |
| Standard Accessories |
■ WNAP-6315 x 1
■ 12V Power Adapter x 1
■ PoE Injector x 1
■ Plastic Strap x 1
■ Quick Installation Guide x 1 |
